喷泉设备维护人员管理：

　　对喷泉设备维护人员进行专业培训的人员，电器设备维护人员还需持有专业上岗证书;每半年对喷泉的操作人员进行考核，加强使用管理。

　　喷泉设备的安装

　　1、喷泉电缆的连接必须在无水的条件下进行，并用防水胶带、绝缘胶带、高压绝缘胶带进行三层防护。

　　2、喷泉水下灯更换必须在无水的条件下进行，并将螺栓紧固牢靠。

　　喷泉设备的检查

　　水下灯的检查：喷泉水下灯要每月检查、紧固一次松动的螺丝，避免灯体进水造成短路故障。

　　电缆的检查：不在水里的电缆半年检查一次，检查老化情况，避免不必要的损失。

　　喷头的检查：为保证喷泉水型的美观和一致，要随时将变动角度的喷头进行复位，复位时禁止使用锐利物体敲击，防止喷头损坏。

　　喷泉电器的检测：喷泉电器设备要定期维护，半年要对柜子里的电器易损设备进行检测级做必要的维护;电器设备的维护检修应在切断电源的条件下进行,如特殊情况需要带电作业时,应做好安全防护措施,重要部位要设专人监护。

　　喷泉设备的更换

　　1、喷泉备用设备要定期启动运行(使用频率高的每天一换，使用频率低的一次一换),防止设备性能减退。

　　2、电磁阀膜片更换时要将脱落在管道内的物体全部清理干静;紧固螺丝时要按对角线顺序进行。

　　3、电脑和程序每年要升级一次。

　　喷泉设备的清洗

　　喷泉水泵的清洗：喷泉水泵吸水口要每月清洗，防止污物堵塞吸口，降低工效甚至造成设备损怀。潜水泵在冬季停用期间必须将冷却水放光，避免结冰损坏泵体，油冷泵需要关闭阀门)

　　喷泉管路的清洗：每年进行一次。冬季喷泉设备停用前应将管道中的水排净，防止管道冻裂。

　　喷泉喷头和水下灯的清洗：半年清洗一次，清洗时注意喷头立管及水下彩灯，防止造成损坏。

　　Fountain equipment maintenance personnel management:

　　Professional training for fountain equipment maintenance personnel, electrical equipment maintenance personnel should also hold professional certificates; Every six months to assess the fountain operators, strengthen the use of management.

　　Installation of fountain equipment

　　1. Fountain cables must be connected without water and protected with three layers of waterproof tape, insulating tape and high-voltage insulating tape.

　　2. The replacement of the fountain underwater lamp must be carried out without water and the bolts should be tightened firmly.

　　Inspection of fountain equipment

　　Inspection of underwater lamp: the underwater lamp of fountain should be checked and tightened once a month to avoid short circuit fault caused by water in the lamp body.

　　Cable inspection: semi-annual inspection of cables not in water to check the aging condition and avoid unnecessary losses.

　　Inspection of sprinkler head: in order to ensure the beauty and consistency of fountain water, reset sprinkler head with changing Angle at any time. It is forbidden to use sharp objects to knock it back to prevent damage of sprinkler head.

　　Fountain electrical equipment testing: fountain electrical equipment should be maintained regularly, six months to the cabinet of electrical equipment vulnerable to detection level to do necessary maintenance; The maintenance and overhaul of electrical equipment should be carried out under the condition of cutting off the power supply. If live operation is needed under special circumstances, safety protection measures should be taken and special personnel should be set up to monitor the important parts.

　　Replacement of fountain equipment

　　1. The standby fountain equipment shall be started and operated regularly (change it every day with high use frequency, and change it once with low use frequency) to prevent degradation of equipment performance.

　　2, the solenoid valve diaphragm replacement should be removed in the pipe objects all dry static; Tighten screws in diagonal order.

　　3. Computers and programs are upgraded once a year.

　　Cleaning of fountain equipment

　　Fountain water pump cleaning: the fountain water pump suction mouth should be cleaned every month to prevent dirt blocking the suction mouth, reduce efficiency and even cause equipment damage. The submersible pump must release the cooling water during the winter shutdown to avoid freezing damage to the pump body. The oil-cooled pump needs to close the valve.)

　　Fountain piping cleaning: once a year. Water should be drained from the pipes before the fountain equipment is out of service in winter to prevent the pipes from freezing and cracking.

　　Cleaning fountain nozzle and underwater lamp: once every half a year. Pay attention to nozzle riser and underwater colored lamp during cleaning to prevent damage.